Detail Italsmea RMS 550 Explossion Proof ( Available For Emergency Service)
Italsmea RMS 550 Explossion Proof ( Available for Emergency service)
RMS.. series lighting fixtures are ideally suited for ON and OFF-SHORE applications and
all kinds of industries where there is an high level of corrosion.
Both body and glass frame are made of stainless steel AISI304 and manufactured from
a single sheet of steel with no invasive mounting holes, to minimize the risk of water
ingress through the housing. Out of holes for power supply cable, whatever protected
by a suitable cable gland ( available upon request) , there are no passing through holes
between inside and outside of luminaire. Therefore during the time there is no risk of IP
rating decrease as it would be possible where, for fixing devices, there are through holes
and relevant gaskets. Design has been studied to allow operator working with free hands
and no need to support any part of lighting fixture. One person can take care of start-up
or maintenance without any aid and assistance. Due to inorganic materials like stainless
steel and glass, RMS.. series lighting fixtures are 95% recyclable; only components and
insulation of single core wires need some more care.
TECHNICAL FEATURES
Material AISI304 stainless steel, 0, 8mm thickness and transparent part in tempered glass ( AISI316L
version available upon request)
IP rating IP65 ( IP66 on request)
Ambient temperature
range
-20° C to + 55° C
Approvals INERIS 01ATEX3002X ( standard)
GOST R ( marking upon request, ordering code to be required)
Marking II 3 GD
Ex-nA II T( * * )
Ex-tD A22 IP66 T( * * )
Gaskets Special cross-section tightness gasket, silicon rubber made ( closed cell) , located in housing
channel between body and window frame.
Entries Body complete of two 21mm Ø through holes ( on one side) for cable entry, one complete of
metallic plug with M20 locknut and gasket and the other one with temporary plastic plug to
prevent dust ingress.
Hardware and screws AISI304 Stainless steel external hardware and screws
Lamps RMS series lighting fixtures are suitable for two pins fluorescent lamps G13 socket Philips
TL-D or equivalent ( lamps excluded)
Ballast High frequency electronic ballast conforming with EN 60079 – 15 and IEC 60079 – 15
Rated operation
voltage ( UE)
220-240 V
Frequency 50-60 Hz
Power factor > 0, 95
Accessories available
upon request
Pole mounting kit
Ceiling mounting kit
Suspension mounting kit
Wall mounting kit
3° - 4° through holes opposite side
Operating principles Available RMS.. lighting fixtures for emergency service of one tube:
- 90 minutes; guarantees 60’ duration with constant flux ( emergency lumen factor 18% ) and
30’ with decreasing flu
Tampilkan Lebih Banyak